Error PC

Error PC

Indication:
      - Error PC message is shown on the tool on screen display.

Description:
      - Error PC can occur when their is messaging misalignment between tool and PC/Controller. 

Possible Cause: 
      A) Two replica tools are communicating on the same channel of the controller.
      B)  PC/Controller has sent or received an unexpected message. 

Remedy: 
      A) Be sure only one tool per controller is powered at a time. 
      B)  Restart the PFCS Connect Software, or a windows restart of the controller.  *Do not hard boot the PC with the controller switch.

    • Related Articles

    • "Blue Screen of Death" - PC Kernel Error

      The below error occurs under the following conditions and is usually caused by and corrected as follows: Possible Cause:    The controller was shutdown suddenly using the switch. -OR- a CELLULAR NETCARD was left in the machine during reboot. Reason: ...

    • Mandrel Stop Error - RK-7XX-3

      Freeset® mandrel STOP (Service warning) If your Freeset tool becomes inoperable and the following message is displayed, then you may have a service block activated on your tool.  The service block provides preventive maintenance warnings at intervals ...

    • Tara Error

      This error typically happens during the first uses of the tool.  As RivetKing only tests 100 placings before shipping and we are unfamiliar with the customers application and selection of rivet nut size.   The electronics and the load cell need to ...